Hello. I will try to explain my issue with an image:
When click 1 numbered dot, it is appending a new card to bottom of the current card. But as I showed in number 2, it adds too far. Can i change this default range?
Page 1 / 1
If you are referring to the default length of the connector line between the existing and new cards, then unfortunately not.
Feel free to review the wish list guidelines here and add a new one if the manual workaround of adjusting the distance after the creation of the new card isn’t acceptable: Wish List: Everything You Need to Know 
| Miro
Kiron
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.